4 in 1 Remote Control Electric Shock Bark Stopper Dog Trainer Collars

Usage method:

1) the first match will be the product: please switch first installed the remote control battery and then open the right side of the remote control device, and then loaded on the receiver battery (battery factory in the packaging has been included: remote control: 9V high capacity battery pack has been installed, for the receiver: AAA 1.5V 7 ordinary alkaline batteries) the lights in the receiver. Please install the receiver battery for 20 seconds (the lights flashing) by shaking key on the remote controller, wait until the receiver begins to shake and make the motion more than 5 seconds before releasing. Shook a remote control button. Then the micro computer receiver has to accept and preserve the signal from the remote control, remote control the other has no effect on it. Some have been prepared for. The function keys on the remote control to control the operation of different dogs.

2) please al receiver battery cover, with an electric shock head (original packaging with a pair of long, short, according to your own dog to choose) gill side outwards, electric direct contact with the dog's skin. Adjust the fixed nylon webbing collar, wear should not be too loose or too tight, elastic to be insert two fingers is appropriate.

3) remote control button function:

Left on the discharge button: this button is a direct discharge; practical in special emergency situations (such as your dog to hurt people, etc.)

Shock for the lower left button: this button is used when not obedient to your dog or yell, the vibration of vocal fold it so that it does not feel comfortable when long time vibration are invalid, it will automatically turn to discharge the punishment.

Right up for the light-emitting key: the function of this key is to issue a relatively bright white light, in an inconvenient time to use, such as: walk the road or light to find your pet, and so on.

The lower right key: a voice for this key for your dog, you can set up. And the sound can be regulated, switch on the right below. (such as: loud by two is representative of dinner, according to a representative of the other and whispered what meaning, you can set up their own training)

On the right side of the remote control switch, above all the operation must first open the switch.

4) to test whether the discharge method: This product discharge, please do not direct contact with human skin test. We have a test with LED lamp in the packaging, the test lamp is fixed on the two discharge, must be confirmed full contact, and then press the discharge button, LED light flashes, said product is the discharge.

User notes

1) although this product design is waterproof, but please try to avoid flooding. So as not to affect the service life of the product. The remote controller does not have the waterproof design, must be waterproof. And do not fall, so as not to affect the performance of the product. The line is loose.

2) this product is a vibration motor type + bark stopper. It is difficult to start, the dog will shake the vocal motor and stop chirping together, so you have a lot of training, when it is called the key you press vibration punishment; give some food reward you when it is time to stop, but please do not just press play your pet. This is not only inhumane will influence the training effect. Please be sure to remember!

3) the effective distance of the remote control of the product is 250 meters in the open environment without interference, which is beyond the scope that the signal is interrupted, and can not work. (250 meters is the straight line distance between the obstacle and the non signal interference).

4) this product is not used for a long time, please put the battery out of the receiver, the remote switch off. It is better to remove the nylon webbing collar also, to restore the factory.

Please note : the battery is not include !