Dry paste method:
1. The part you want to paste clean锛?dry;
2. Strip part or all of the backing paper锛?set a good position锛?the fixed upper end锛?the sticker affixed to the car body from top to bottom;
3. scraped back and forth with a plastic scraper or bank card锛?completely out of the air;
4. Finally quit transfer film锛?it's done.
Wet paste method:
1. I want to paste the site clean;
2. Strip completely backing paper锛?sprayed with an aqueous solution of detergent in the rubber surface of the vehicle body paste parts and stickers;
3. To be a good location锛?the sticker affixed to the body carefully with a plastic scraper or bank card to the middle of the sticker around an appropriate force scraping锛?completely out of the water and air;
The natural air-dried for 30 minutes and finally thrown off the transfer film.
Car stickers clear
1 sparkling clear: After the adhesive is completed sometimes occur on the surface of the bubble sizes of stickers锛?foaming at the edges with a thin needle prick a few holes锛?then direct the air expelled by hand锛?do not try to hand directly to the blistering crushed.
Clear sticker: 1. Nail whipped corner and then the entire tear off without leaving any traces锛?not to hurt the primer.
2. When the cold weather can not be swept corner first with a hot air gun stickers proper heating锛?and then hand carefully removed from the body surface stickers!
3. For remaining on the surface of the body with alcohol to remove the residue!
