WARNING~Do not  wrongly select  6v 12v 24v otherwise it will burn and battery charger! ! ! ! !

Usage: battery charger connected to the positive red folder, mung then the battery negative, is not reversed, this time charging machine began to work, need to use a new battery low bit (1-2 files) charging time is 10-12 hours. If the battery is used, can be adjusted automatically, fast charge can also be slow charge, if the charge for a long time, they could not name the car, indicating that the battery needs to be replaced with new extreme aging batteries,

Overcurrent protection: The machine is equipped with over-current protection switch, when the current exceeds the set current when charging automatically shut off to protect the charger and battery when a short circuit, reverse polarity, over-current protection switch will automatically disconnect after troubleshooting, click the overcurrent switch, charger is working properly.

Shutdown current position 0 is "off" off position, backlash finished battery, disconnect the power remove the battery clip, and the clip of the sulfuric acid clean dirt, etc. After cooling, another collection is good, the next use only.

  1; coil and electronic charger charger contrast, electronic lighter intelligent charging machine some weight size are relatively small, there will be full of tips (but even after full charge 3-4 hours before tips). Electronic drawback: too many electronic components inside too complex, so the electronic charging machine components as long as there is one or two bad, the charger will not work properly. And because too many components, difficult to identify cause of the malfunction, should generally bad Depot Repair. The coil is relatively bulky charger, charging effect is good, simple in principle. Principle: AC 220V AC power through the transformer out of 14-16V, and then through the rectifier bridge into a DC, it can be charged. Because the principle is simple and less components, it is generally not broken. And after the transformer out of the electric charge effect to be better.

2; on copper and protection of the machine, is 100% pure copper, copper coil transformers to be more durable than aluminum coils, heat smaller. The only protection a fuse and overcurrent protection switch.

3; for many customers on the line when it comes to this issue too thin is too short, to explain. As we all know, the thicker the line must be better, but all businesses want to reduce costs. The input and output lines are in line with the standard of our machines, it is properly used. For 220V input can be extended a lot, you can be connected to the socket. But for output terminal it is not too long, because the longer the line, the greater the resistance, blood pressure and more, it will affect the charging effect. "

  注：切勿6v  12v  24v开错 否则会烧毁充电机和电瓶！！！！！