The stage 1 kit gives you a good boost in power while replacing the parts necessary to handle the increased spring tension. All parts are cast out of metal alloy and fitted to be compatible with your blaster.

Installation is as simple as removing the parts to be replaced and dropping in your new reinforced parts.

Included in this kit:

• Trigger catch
• 2x double strength trigger catch springs
• Reinforcement plate
• 5+ kg mainspring (2.5kg stock)

*Modifying blaster may wear out or damage components. Please do so responsibly and at your own risk!

Specifications:

• 5mm Metal alloy trigger catch
• 1mm Metal alloy reinforcement plate
• 2x .75kg trigger catch springs (.365kg stock)
• 5kg fire compression mainspring (2.5kg stock)

100fps muzzle velocity with up to 75ft range (parallel to ground) 
100fps muzzle velocity with up to 85ft range (30 degrees angled to ground)
Be sure to watch our FPS Test Video for this product.

Installation:

1. Remove screws from blaster.
2. Open blaster (gently pry the seam with a flat head screwdriver if needed).
3. Locate and remove original mainspring, trigger catch, and trigger catch spring.
4. Install new Unleashed: Solid Kit 1 mainspring, trigger catch, and trigger catch spring.
5. (optional) Take the reinforcement plate and fit it into the black end cap of your blaster.
6. Reassemble your blaster.

It is advisable to lubricate all metal to metal and metal to plastic contact, in order to keep the action of your blaster smooth.

Be sure to watch our Troubleshooting Video for this kit if you experience any difficulties during installation.