Descriptions:

1.Anti fog glass

2.CMOS imaging sensor

3.Support NTSC video system

4.Embedded mounting in rear bumper

5.Snap-in design， it is easy to install

6.High sensitivity and low power consumption

7.High-definition and 170 degree wide viewing angle

8.Water-proof， shock-proof and anti-jamming functions

9.Applicable to variety of vehicles: car， truck， RV， etc.

10.It helps to avoid incidents and accidents abrasion well

11.Extra-low illumination of 0.5 Lux for clear night vision.

12.Its simple and modest design and small size won't draw any attention

13.This camera can give you a full sight of the back of your car when you are driving.

14.Low illumination level， it can work within 3 meters at night and other dark environments

15.To protect your car from collision with invisible obstacle， choose a high definition and good quality camera as ours.

16.Perfect solution to get rid of that poor rear view visibility onyour car， boat， trailer， camper， truck or any vehicle that has no rear-view mirror or poor rear vision

17.Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted inside will fit into most vehicle key holes， no other installation needed



Specifications:

Lens: 2.0cm

Color: Black

TV System: NTSC

S\/N Ratio: !#!amp!*!gt;48dB

Net Weight: 203g

Water-proof: IP66

Power: DC 12V!#!amp!*!plusmn;10%

White Balance: Auto

Sync. System: Internal

Video Cable Length: 6.0m

Video Output: 1.0Vpp， 75Ohm

Length Angle: 120~170 degree

Cable Length of Camera: 56cm

Scanning System: 2:1 Interlace

Power Supply Cable Length: 99cm

Image Reverse: Left-right mirror

High grade of waterproofing: IP66

Horizontal Resolution: 420 TV lines

Camera Size: 4.5(W) x 2.5(H) x 4.0(L)cm

Effective Pixels: NTSC: 510(H) * 492(V)

Current Consumption: No More Than 300mA

Image Sensor: CMOS 1\/4 MT9V125 or PC1030， color

Minimum Illumination: 0.2 Lux\/ F1.8(0 Lux with LED)

Storage Temperature: -30\u2103 to + 60 C， 95% RH maximum

Operating Temperature: -20\u2103 to + 60 C， 95% RH maximum

Electronic Shutter: 1\/50 to 1\/100，000 seconds， 1\/60 to 1\/100，000 seconds



Installation:

1.Mount the camera inside the keyhole of your vehicle.

2.Adjust the lens of the camera to its best position.

3.Connect power cord to connect to your vehivle DC 12V power system.

4.Connect the video output(yellow) of the camera to the display in your vehicle.



Package Included:

1 x Video Cable

1 x Power Cable

1 x User manual

1 x Car Rear View Camera

2 x Screws(For Bracket Mount)