Specification
System performance
Power source	Four 1.5V AA alkaline batteries
Size of monitor w/o cuff	160 (L) x 95 mm (W) x 66.5 mm (H), 400g with batteries.
Cuff Size	24-43 cm (9.4 - 16.9 inches) with air tube 100 cm
Memory	Maximum 60 memory records
Power saving	Automatic power off if system idle for 3 minutes
System operating conditions	10°C to 40°C (50°F to104°F), below 85% RH
Meter storage conditions	-20°C to 60°C(-4°F to140°F), below 95% RH
Power Supply Input	DC +6V / 1A (max) via Power Plug
Blood pressure measurement performance
Measurement unit	mmHg
Systolic Measurement Range	50 mmHg -255 mmHg
Diastolic Measurement Range	25 mmHg -195 mmHg
Pulse Rate Measurement Range	40 -199 beats / minute
Accuracy of Pressure	±3 mmHg or ±2% of reading
Accuracy of Pulse rate	±4% of reading

How To Use (Blood Pressure)
Before Measurement
1. Sit down for at least 10 minutes before measuring. 2. Place your elbow on a flat surface and relax your hand with the palm facing up. 3. Apply the proper pressure cuff and make sure the cuff is at the same height as your heart.

Taking Measurements
Single Measurement
1. Press to start. Then the cuff will begin to inflate automatically. 2. The "heart symbol will flash when a pulse is detected during the inflation.
3. After the measurement, the monitor will display the systolic pressure, diastolic pressure and pulse rate
Averaging Measurement (for FORA P30 Plus only)
1. Press to start. Then the cuff will begin to inflate automatically. 2. The monitor will take 3 measurements consecutively.
3. After 3 measurements are completed, the results are averaged and displayed with "AVERAGE symbol" on the monitor
Auscultatory Measurement (Only well- trained staff may use this mode to measure blood pressure manually.)
1. Press and hold until "AUS symbol"appears on the display with a beep. The cuff will begin to inflate and then deflate automatically. 2. Press to adjust the inflation pressure if necessary, and release to start the measurement.
3. The systolic pressure is measured when the operator first hears the sound of the pulse. Then the diastolic pressure is measured until the sound of the pulse disappears. 4. The monitor will return to 0 mmHg after the measurement is completed.