Universal design for pulling off front hubs and aligning interference fit spline half shafts during installation
Removes and installs front hubs during CV joint replacement, transaxle and wheel bearing servicing without damaging wheel bearings
Additional locknut enables the use of a standard slide hammer puller for removal of rear axle flanges

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 6.5 inch
Height : 4.3 inch
Length : 10.8 inch

Item Weight: 1.32 pounds (View shipping rates and policies)
Shipping Weight: 4.1 pounds (View shipping rates and policies)

ASIN : B00A4AJP7A

Product Description

The Front Hub Remover and Installer Set is a universal design for pulling off front hubs and aligning interference fit spline half shafts during installation. It removes and installs front hubs during CV joint replacement, transaxle and wheel bearing servicing without damaging wheel bearings. An additional locknut enables the use of a standard slide hammers puller for removal of rear axle flanges.