color2 ?Plastic suction tin

吸锡器使用方法:

?1、先把吸锡器活塞向下压至卡住。

?2、用电烙铁加热焊点至焊料熔化。

?3、移开电烙铁的同时，迅速把吸锡器咀贴上焊点，并按动吸锡器按钮。 ?4、一次吸不干净，可重复操作多次。

吸锡器使用技巧:

?(1)要确保吸锡器活塞密封良好。通电前，用手指堵住吸锡器头的小孔，按下按钮，如活塞不易弹出到位，说明密封是好的。

?(2)吸锡器头的孔径有不同尺寸，要选择合适的规格使用。

?(3)吸锡器头用旧后，要适时更换新的。

?(4)接触焊点以前，每次都蘸一点松香，改善焊锡的流动性。

?(5)头部接触焊点的时间稍长些，当焊锡融化后，以焊点针脚为中心，手向外按顺时针方向画一个圆圈之后，再按动吸锡器按钮。
Suction tin use:

? 1， the first suction tin piston downward pressure to get stuck.

? 2， electric iron heating pad until the solder melts.

? 3. Remove the electric iron at the same time， quickly put the suction nozzle tin solder paste， and presses the suction tin button. 4， once the suction is not clean， repeat the operation several times.

Suction tin tips:

? (1) To ensure that suction tin piston seal is good. Before electricity， stick a finger suction tin head hole， press the button， such as the piston is not easy to pop into place， indicating that the seal is good.

? (2) suction tin head aperture different sizes， to choose the right size to use.

? (3) After the first suction tin old， to the timely replacement.

? (4) before the contact pads， each time a little dip rosin， to improve the flow of solder.

? (5) contact pads of the head slightly longer period of time， when the solder melts to solder pin as the center， hands outward in a clockwise direction after drawing a circle， and then press the suction tin button.