MC-DY602 0.5A-1A DC 600kV High Voltage Pulse Iverter Arc Generator 9x2.7cm Specifications:
Module type: MC-DY602
Input voltage: 3.7V-7.4V
Input current: 0.5A-1A
Input wire length: 27 cm
High voltage type: pulse DC type
Output voltage: 600KV or so (when used， please pay attention to security)
Output current: 0.5A-1A
Output wire length: 18 cm
High voltage discharge distance: 2 cm -5 cm
Size:9x2.7cm

About input power:
Can use single section 3.7V lithium battery or two series， such as 18650 battery，
the idle mobile phone battery (to remove protective plate， proposed capacity above
2000mAh) or nickel cadmium \/ MH Ni battery， 4V or 6V lead-acid batteries and
other (to achieve the best effect of 6V battery)

Module use note:
1， high voltage module should avoid the use of high voltage no-load， power must be
adjusted before the high voltage line end of the right distance， high voltage wire
drawing distance and the use of battery voltage and capacity is proportional to.
2， the test arc distance from short to long experiment， when the power is prohibited
beyond the longest arc distance， due to the high pressure energy can not be released，
very easy to damage the module.
3， the power of the module， the internal heat is not heat， so not a long time to work.
4， determine whether the battery capacity of the output of the maximum power of the method
is to measure the battery voltage when the pull arc. If the maximum power output is around 6V.
5， The small capacity of the two series lithium 7.2V， with more than 2000MA lithium
recommendations

Note:
The size of the input voltage will affect the output high voltage and arc distance.

Package included:
1 X High voltage inverter