4.3Inch TFT LCD Car Rear View Monitor+CMOS Waterproof Reverse Camera

Item 1: Car Rear View Monitor
Feature:
1.Easy to install and use
2.High resolution display
3.Low power consumption
4.Supports screen rotatable
5.Stick on your car firmly and stablely
6.No audio and input or output
7.Full color LED backlight display
8.4.3” LED Backlight Color TFT LCD monitor
9.It helps to avoid incidents and accidents abrasion well
10.Support Car DVD, VCD, GPS, camera, STB, satellite receiver, and other video equipment
11.Park rear view priority: The monitor will start up automatically, and synchronous display
the video from rear view camera when you are backing your car, the monitor will close itself after backing

Specification:

Color	Black
Aspect Ration	4:3
Screen size	4.3 inch
Resolution	480x272
Power supply	DC 9V-36V
Housing Material	ABS
Video input	One way video input
Display Component	Color TFT LCD

Item 2: Car Rear View Camera
Feature:
1. Anti fog glass.
2. CMOS imaging sensor.
3. Support NTSC video system.
4. Embedded mounting in rear bumper.
5. Snap-in design, it is easy to install.
6. High sensitivity and low power consumption.
7. High-definition and 120 degree wide viewing angle.
8. Water-proof, shock-proof and anti-jamming functions.
9. It helps to avoid incidents and accidents abrasion well.
10. Its simple and modest design and small size won't draw any attention.
11. This camera can give you a full sight of the back of your car when you are driving.
12. To protect your car from collision with invisible obstacle, choose a high definition and good quality camera as ours.
13. Perfect solution to get rid of that poor rear view visibility on your car, boat, trailer, camper, truck or any vehicle
hat has no rear-view mirror or poor rear vision.
14. Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted
inside will fit into most vehicle key holes, no other installation needed.

Specification:

Lens	2.0cm
Color	Black
TV System	NTSC
S/N Ratio	>48dB
Water-proof	IP66
Power	DC 12V±10%
White Balance	Auto
Camera Size	22*21mm
Sync. System	Internal
Video Cable Length	6.0m
Video Output	1.0Vpp, 75Ohm
Length Angle	120 degree
Cable Length of Camera	59cm
Scanning System	2:1 Interlace
Power Supply Cable Length	41cm
Image Reverse	Left-right mirror
High grade of waterproofing	IP66
Horizontal Resolution	420 TV lines
Effective Pixels	NTSC: 510(H) * 492(V)
Current Consumption	No More Than 300mA
Image Sensor	CMOS 1/4 MT9V125 or PC1030, color
Minimum Illumination	0.2 Lux/ F1.8(0 Lux with LED)
Storage Temperature	-30℃ to + 60°C, 95% RH maximum
Operating Temperature	-20℃ to + 60°C, 95% RH maximum
Electronic Shutter	1/50 to 1/100,000 seconds, 1/60 to 1/100,000 seconds

Notice:
The product would come without three button on the back side.

Installation:
1.Mount the camera inside the keyhole of your vehicle.
2.Adjust the lens of the camera to its best position.
3.Voltage can not exceed 11v.
4.Connect the video output of the camera to the display in your vehicle.

Package Included:

1 X Video Cable	1 X Power Cable
1 X Installation of Visual Reversing	1 X Car Rear View Camera
2 X Screws