Widely used chip-breaker is used for semi-finishing and finishing of steel and stainless steel
Ticn based Cermet, with fine resistant Thermoplastic transmutation and resistant built-up
It is suitable for semi-finishing and finishing of steel, stainless steel and cast iron
Hole diameter is 0.15 inch
Measures 29/64'' Length by 3/16'' width

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 1.45 inch
Height : 1.19 inch
Length : 2 inch

Item Weight: 0.32 ounce (View shipping rates and policies)
Shipping Weight: 1.02 pounds (View shipping rates and policies)

ASIN : B01LW776WU

Product Description

HHIP DNMG/DM 55 degree diamond-negative rake Carbide insert is made of Carbide. Dm - widely used chip-breaker is used for semi-finishing and finishing of steel and stainless steel. Xab749: cutting edge with special strength and toughness, in an optimal combination with mt-ticn, thick layer al2o3tin coating. It is a suitable grades for a wide application. It is good for the finishing, semi-finishing and light roughing of steel, cast steel and stainless steel. Stainless steel and cast iron. Asa insert no is dnmg-331-dm. ISO insert no is dnmg110404dm. Measures 29/64'' Length by 3/16'' width. Hole diameter is 0.15''. I.C. Is 3/8''. nose radius is 0.0157''.