Made of bronze for higher strength and corrosion resistance than brass
Zinc-plated steel lever handle with vinyl sleeve for manual on/off control
Stop and waste (or drain) design to prevent water lines from freezing
Full port flow for higher operating efficiency than standard port
Solder end connections on both ends for a semi-permanent connection to tubing

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 3 inch
Height : 1.5 inch
Length : 5.6 inch

Item Weight: 0 ounce (View shipping rates and policies)
Shipping Weight: 2 pounds (View shipping rates and policies)

ASIN : B006G1RZEG

Product Description

The Apollo 95-200 series bronze inline stop-and-waste (or drain) ball valve has a lever handle and solder end connections on both ends. It is made of bronze for higher strength and corrosion resistance than brass, and has a zinc-plated steel lever handle with a vinyl sleeve for manual on/off control. This valve has a drain with cap to allow the draining of water beyond the valve shut off point to prevent winter freezing of the water line. The valve is full port for reduced friction; its inner diameter is the same as the inner diameter of the pipe it connects to for maximum operating efficiency. It has solder ends for semi-permanent yet reversible connections to tubing. The reinforced polytetrafluoroethylene (RPTFE) seats reduce the risk of leakage, and the drain cap has a seal to prevent fluid loss. The maximum pressure rating is 400 pounds per square inch (gauge) (psig) for water, oil, and gas (WOG), and the temperature range is -20 to 450 degrees Fahrenheit. This ball valve is for use in water lines, processing plants, and agricultural applications and meets standard MSS SP-110 for quality assurance.
Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hole of the ball is the same size as the inner diameter of the connecting pipeline (resulting in lower friction) and is reduced port if the hole of the valve is one pipe size smaller than the pipe, resulting in less flow through the valve than through the shaft of the pipe. Ball valves may have a handle or lever that aligns with the ball’s position (open or closed) for manual operation. They are primarily used in air, gas, liquid, and steam applications.
Apollo manufactures ball, mixing, and relief valves, actuators, water gauges, marine fittings, heating and plumbing products, and backflow prevention devices. The company, founded in 1928 and headquartered in Matthews, NC, meets International Organization for Standardization ISO/IEC 17025:2005 and makes products that meet ISO and American National Standards Institute (ANSI) standards.