●类别：切割雕刻类车贴
●材质：台湾皇冠KK车身专用材料，耐高温，表面防污UV涂层，富有光泽，质感如车漆、防水防晒、不退色，
洗车打蜡都不影响，撕除不留残胶、不伤车漆，配送转贴膜；
●规格：依照车身正常比例
　　　 　马自达6 马自达3三厢车身比例(默认发货尺寸)

●贴纸颜色：银灰色＋白色字 [适合贴:黑色车，深灰色车，红色车，蓝色车] [不反光](默认发货颜色)
　　　 　 　　深灰色+黑色字?[合适银色车，] [不反光]
　　　 　 　　银灰色＋白色 [适合贴:黑色车，深灰色车，红色车，蓝色车]?[不反光]
　　　 　 　　自定义其它颜色　[有反光色，价格稍贵，向店主询问]

●价格包括：车身两侧＋车头（不包括风挡）

★注意：反光白颜色在自然光下呈银白色，反光时呈亮白色；黑色与灰色没有反光材料。

　　　　★★★其它车型可以定做这套，MZDSPEED英文可以改别的★★★

如果您不是马自达的车型，可以选择下面车身上的英文，RACINGSPEED。意思是运动速度


Material: Stickers

Dry paste method:
1. The part you want to paste clean， dry;

2. Strip part or all of the backing paper， set a good position， the fixed upper end， the sticker affixed to the car body from top to bottom;

3. scraped back and forth with a plastic scraper or bank card， completely out of the air;

4. Finally quit transfer film， it's done.


Wet paste method:
1. I want to paste the site clean;

2. Strip completely backing paper， sprayed with an aqueous solution of detergent in the rubber surface of the vehicle body paste parts and stickers;

3. To be a good location， the sticker affixed to the body carefully with a plastic scraper or bank card to the middle of the sticker around an appropriate force scraping， completely out of the water and air;

The natural air-dried for 30 minutes and finally thrown off the transfer film.

Car stickers clear

1 sparkling clear: After the adhesive is completed sometimes occur on the surface of the bubble sizes of stickers， foaming at the edges with a thin needle prick a few holes， then direct the air expelled by hand， do not try to hand directly to the blistering crushed.

Clear sticker: 1. Nail whipped corner and then the entire tear off without leaving any traces， not to hurt the primer.

2. When the cold weather can not be swept corner first with a hot air gun stickers proper heating， and then hand carefully removed from the body surface stickers!

3. For remaining on the surface of the body with alcohol to remove the residue!