Loctite re-new is an innovative solution for repairing ugly looking caulk in your kitchen and bathroom. Easily repair molding, Yellowing and cracking old sealant joints in only one-step. No need to take out the old sealant, just pass over the existing sealant with Loctite re-new specialty silicone for a long lasting and durable seal. As easy as using a highlighter with professional-like quality. Loctite re-new kills, repels and prevents mold from growing Once properly applied. One tube of Loctite re-new covers one typical shower/tub application. Re-new your caulk like new, with Loctite re-new.

• Apply on top of existing sealant, revives old or damaged sealant, no need to remove the old
• Triple protection mold resistance repels, kills and prevents mold
• Flexible and waterproof
• Great adhesion to existing sealant, including silicone
• Integrated auto-smoothing applicator for a perfect result

• Manufacturer: Henkel Adhesives

Recommended For

Covering over existing silicone seals.
Refreshing triangular joints in bathrooms, showers, toilets, laundry rooms and kitchens
Repairing damaged silicone sealant joints.
Refreshing connection joints between sinks and wall, floor or ceiling tiling.

Not Recommended For

Covering glazing sealants
Joints with water pressure or permanent water immersion (ie. Swimming pool, aquariums, etc.)
Applications in contact with foodstuffs
Bituminous substrates
Polyethylene, polypropylene, polytetrafluorethylene, acrylic, FRP, vinyl surfaces, mirrors or natural stone
Building materials which might bleed oils, plasticizers or solvents that could attack product

 

Safety Precautions

Wear safety glasses and gloves and wash hands after use.

Preparation

Ensure all joints and surfaces are clean and free of grease, dust, water and other contaminants. Molded sealants should first be cleaned with mold remover then thoroughly rinsed with water. Ensure surface is dry before applying RE-NEW.

Application

Remove the cap and position the applicator at an angle (approximately 90°) to the joint so that the edges of the applicator have full contact with both faces of the joint. Squeeze out the product while moving the applicator along the joint making sure that the product is in full contact with the sealant to be coated. If unsatisfied with bead, remove product immediately with a damp cloth and apply again. In case of vertical joints, it is recommended to apply the product from the bottom up. If it is necessary, pass over the joint again without pressing. Wait 6 hours before water contact and avoid contact with cleaning agents for 24 hours after application.

Cleanup

Clean applicator with a damp cloth after use and close the cap. Cured sealant must be carefully cut away with a sharp-edged tool.