If the lighting fixtures illuminate a wide area, it may be better to change each appliance obediently

In order to turn the ceiling fluorescent light (40 + 32 + 30 W) of the living room into LED, some 30 H type is purchased for about 2 k yen at Homsen CH. Since it is not possible to do things like one device with LED on one side and fluorescent light etc on the other, it is purchased for total W type totaling 7.5 k yen. As it has already been confirmed that there is no glow in the lighting equipment, we immediately removed the original fluorescent light and started attaching. The plastic of the installation part is tight against the folder on the lighting equipment side, and when you press the plastic part on the fluorescent light side, it opens it. Although it is not impossible, this point should be improved by the manufacturer. I could somehow push it in because I could not do anything with the floating connector. When I tried to light up, I was able to do both maximum lighting and dimming lighting of the inverter. It is + evaluation that it was unnecessary for inverter type inverter and dimming lighting was possible. (I think that there is not much in others.) There was also a content saying that it was only possible to turn on the maximum if it was made into an LED, and there was also writing such as a broken sound immediately after it glowed on when connected I was fine, though. Compared to the existing fluorescent lamp of full circumference lighting, this product is not all around lighting, there is no light distribution to the upper side (this is no problem for sealing), the lower side is also LED so it is good right down, but wide range I felt it was a bit dark as a purpose to light up. (It is usable without being problematic, but it is compared with fluorescent light.The family has not changed because it seems unnoticeable, so it may not be enough to care.) The original lighting fixtures In the case of a device with a large wattage, I think that it is a type that illuminates a wide range, so in that case, using a round LED fluorescent lamp is disadvantageous and it may be good to use it in lighting a range not so wide not. If you feel it is dark, do not use the inverter's dimmed lighting, the power consumption is half of the fluorescent light, so I think that it should be used at maximum lighting. In the case of a wide range, the cost will be about 1.5 times obediently for each tool, but after all we think that there is merit. I tried to see what kind of commercially available LED fluorescent lamp of the pendant type (so-called pulling type), but after all, there was no light distribution to the ceiling side, but the distribution to the lower side devised the arrangement of the LED It seems that ordinary broad light distribution is normal. When using a round LED fluorescent light with a pendant device, I think that it would be better if the appliance is made as close to the ceiling as possible to achieve wide light distribution. I went to Homsen CH on 11/19, and the LED circle lamp of Eco Devices' wide light distribution 240 degree type was out. I came back home thinking that it might be advantageous for pendant lighting. I wanted it to be issued sooner. We got a wide light distribution 240 ° type of 12/10 Homsen CH. Depending on the equipment used, the noise during lighting may increase compared to fluorescent light, and it seems that it is not the same as this one. Especially when the appliances themselves are old, or when checking again at the time of fluorescent lighting, the noise is coming out and it is feeling that it increases further if it is done here. Moreover, it was not possible to use it with flicker when trying to use it as a pendant which was OK here. Since there seems to be a compatibility problem by all means it is better to check immediately after purchase in either case. If you connect directly, it probably will be better, but it is not done because it is troublesome. Manufacturer think that it is good to describe correspondence in such a case in the package.

Easy

The price is higher than ordinary fluorescent tubes, but I bought this from the late electricity bill. Also, with the merit of easy exchange, it really is really easy and is not it? Besides, it is brighter than the previous fluorescent tube, well, it was good at this price.

Easy, bright and GOOD!

Compared to buying luminaires themselves, the initial cost is cheap, and if the electricity bill becomes cheap, is not it.

Purchase

Since the fluorescent light of the living room has run out, I tried to change my mind to LED and bought it. Just replacing it, it is very bright and I am very satisfied.