????Price for a single price

[Installation]
Dry paste method: a small car stickers applicable
1. The vehicle body mount positions require clean， and loosen with a clean towel to dry state;
2. Direct the end of paper torn stickers， affixed to mount parts， evenness with scraper (or bank card);
3. Finally， carefully remove the transfer film sticker top.
Wet paste method: a large car stickers applicable [recommend Double Action] tools: watering can， clean rag， scraper， utility knife， bake gun.
1， clean body， the body parts will be posted with a watering can spray - is mainly used to reduce the sticker viscosity， easy to adjust the position.
2， to determine the need to paste a good position， the transfer film (paste-paste transparent reflective film) together with car stickers from right to left to [or from a downward] aside and lift it with a cloth pressed against the car on the table， and then paste while， while flatten with a rag， while Jiedi paper.
3， face the door handle or crash of the material to be cut and pack into or carried out according to the situation.
4， adjust the graphics in general determine the correct location， with a scraper repeatedly scrape the water and bubbles， using the scraper scraped from right to left oblique; and finally peel off the transparent transfer film.
5， the case of the doors and sewn at the average cut open with a knife， inward package fit.
6， try to make car stickers in the water dry， can afford to use air guns moderate heating and drying.
Precautions:
1. The cold winter areas or relatively low temperatures， occur when opened in the case of transfer film car stickers sticky end of the paper， parents can transfer film while slowly opened， encounter up pattern with a scraper or a bank card via transfer film scraping a few more on it.
2. mount should be careful not to let the sticker itself be taken to avoid stuck together;
Try not within 3.24 hours exposure， should not wash within 48 hours， because this time is not completely pasted stickers， high pressure water jet washing will affect it. Two days later， the car wash is harmless.
Removal method: If the car stickers do not， I want to get rid of， first with a hair dryer or heat gun roast， following the car stickers plastic to soften， then tear it directly， without leaving any offset， do not hurt the paint.