Ultra lightweight aluminum alloy construction

Fix the needle tube here and tighten the tube vise

Latest bearing technology makes this machine almost silent

Ventilation design to allow the motor to breath freely, preventing overheating

Debugging of tattoo machine:

• Step 1: Hold the tube with your left hand and the forefinger withstands the bottom of Host Frame and presses the location of Tube Clamp.
• Step 2: Connect the machine to AC power through inserting the clip cord into the jack of the tattoo machine.
• Step 3: Unscrew the Hex screw with the right thumb and forefinger until it is in loose condition.
• Step 4: Unscrew the Contact Screw with the right thumb and forefinger.At the same time, you should step on the Foot Pedal with your right foot to start up the tattoo machine.
• Step 5: When adjusting the Contact screw, please remember that your right fingers should stay still on the button until the tattoo machine produces operating sound with optimal speed.Meanwhile, the left thumb touches the Top Hat Grommet button underneath to feel the vibration.If your thumb experiences numbness and itching, it means that the tattoo machine is in the optimal working condition.
• Step 6: You should pay attention to the machine▽s distance (the intervals between the armature bar and coils) when debugging the machine.That is, the distance should be maintained at least 2.5mm, so that the needle has enough flexible distance for the tube tip to stretch out to pierce the skin and to retract to the tube to soak the tattoo ink.
• Step 7: Under the optimal working condition, the tattoo machine would power off after your foot leaves the Foot Pedal.And then you should tighten the Hex Screw and lock the Contact Screw under the shutdown condition.

You should reboot the tattoo machine to test its performance after finishing the seven steps above.The optimal working condition means finishing the debugging of the tattoo machine.The voltage is 9-12V during liner and 12-12V during coloring or shading with a professional voltage regulator.

• If the sound and vigor would be perfect after finishing the no-load debugging of tattoo machine, you should firstly install the grip to screw up the screw slightly. Afterwards, it is time to install the needle.
• Please check whether the needle is in good condition or not. If so, place the T rubber band on the ring of needle bar, insert the tattoo needle into the tube from the top of the grip and then put the rubber band around the cylinder of the armature bar.
• Mount the tube and adjust the location of grip. Hold the tattoo machine with the left hand to press down the armature bar emphatically with your thumb to make contact with the iron surface of the coils. And then adjust the grip with your right hand to stick out about 1-1.5mm tip outside the tube.
• Place the rubber band about 8mm below the needle bar and band the needle bar and the machine body with the rubber band. Please pay attention to the moderate tightness. Loose rubber band would result in the breaking away of the needle. Inversely, it would affect the rotate speed. After those steps are done, the tattoo machine can start up to work.

Ultra lightweight construction adds precision to your tattoo work!

FEATURES

• New and high quality
• Can be easily tuned as a liner or a shader
• Strong, hardworking, normal working 8 hours.
• A special process, the dry little voice
• Fast shading
• Using high temperature heat treatment, unwarming for long time using
• Both liner and shader
• Its steady body and smooth vibration will make your tattooing much more professional
• This tattoo machine is a pro-quality beauty product with everything you▽ll need to tattoo
• Perfect for any tattoo artist looking for a good quality tattoo machine

Specifications

Package Includes

• 1 x Aluminum Alloy Rotary Liner Shader Tattoo Machine Blue 007

Extra Info