Material: ABS Color: BlackQuantity: 1 pc3 Buttons: Lock，unlock and panic.Size��66 x 30 x 10mm / 2.6" x 1.18" x 0.39" (LxWxH)With all electronics and a battery installed. Interchange Part Number : KBRASTU15Other Part Number : 28268-7Z800 28268-C990A COMPATIBILITYPlease use the compatibility chart drop down menu above to double check if this will work for your car. Your vehicle must have a factory installed keyless entry system for this to work. Fitment:2005-2010 Nissan Armada2002-2010 Nissan Frontier2004-2009 Nissan Quest2004-2009 Nissan Titan2003-2007 Nissan Murano2002-2004 Nissan Pathfinder2002-2004 Nissan XterraNote:1. Please check your key look the same as the one in our product picture above before you purchase.2.You do not need any existing remotes to program a new one.The remotes are self-programmable， saving you time and money. Please follow these instructions:1.Close and lock all doors with the driver's side power lock / unlock switch located on driver��s door panel.2.Insert key into ignition (DON'T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds (this will need to be done at approximately one second intervals). Your hazard lamps will flash if you have performed this step correctly. PLEASE NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast or too slow the system will not enter programming mode.3.Insert key into ignition and turn to the ACC position (as far as you can go without starting the car).4.Within 5 seconds， push the LOCK button on the keyless remote. Your hazard lamps will flash. PLEASE NOTE: Do not press the button on the remote more than one time or the programming will not be successful.5.If there are any remaining remotes (including working ones)， Unlock then Lock all doors using the switch on driver��s door panel. Within 5 seconds of locking and unlocking doors press LOCK button on the next remote. Your hazard lamps will flash. Repeat this step for each remote (including any working remotes).6.When all remotes have been programmed turn the key to the OFF position， remove keys from the ignition， unlock doors using the driver��s side power lock/unlock switch and open the driver side door. Test all remotes. Package includes: 1 x Remote key