Product Name: car 500A battery line /2 meters battery connecting line of 12V emergencytake fire ignition wire / Jiang Long

Specifications: length: 2 meters， net weight: 0.6KG

Explain.

When your car because don't worry no power could not beat the car from the side of the road， hit a taxi at a clip easily. Very few cars had no electricity， but once in a while have no electricity， really annoying. Not afraid of ten thousand， just in case， or take a battery clipwill be good. Without any menace from the "rear".

[step]

A red clip head 1， link cable (+) to post positive dead battery.

Another red clip head 2， connecting cable (+) to the terminal of the battery cathode.

A black clip head 3， connecting cable (-) to the negative terminal of the battery.

4， the cable is another black clip head and the engine casing or the automobile body is connected.

5， start， please instantaneous operation， have a 10 second cooldown between adjacenttwo start.

6， unloading cable steps in reverse installation procedures.

[note]

1， in strict accordance with the operation steps.

2， check the battery voltage of two mark， to ensure that the voltage two battery of the same.

3， shut off the car all load， neutral position， pull the hand brake， start the engine.Smoking is forbidden in the vicinity of the vehicle.

4， if the car battery has been frozen， prohibit， or it may cause an explosion.

5， make sure that the battery terminal correct polarity.

6， during the operation， vehicles can not contact with other vehicles.

7， the battery will produce explosive gas! Install the cable when you wear protectivegoggles.

8， if the acid storage battery in the inadvertent leakage， splash the skin or eyes， rinse immediately with plenty of water， and then ask a doctor for help.

Special copper wire line emergency battery car battery on line battery cable Jiang Long600A