?????

Screen paste method:

1， first with the package with a small cloth to clean the screen surface dust.

2， to determine the direction and order of paste， tearing the fraction oflabeled "1" from the film， ready to paste.

3， in the film， torn part "from the film"， the screen with good alignment， andside edge tear paste， paste until completely.

4， stick good protective film， then tore off the mark "，" second "release film".

5， finally completely tear up "from the film"， you can put to use mobile phone.

The back paste method:

1， first with the package with a small cloth to clean the screen surface dust.

2， to determine the direction and order of paste， tear film attached on paper

3， to determine the direction and slowly tear paper， film will automaticallyadsorption up， can tear up reuse.

Use the matters needing attention:

★ the film before must ensure that the screen is not a little dust

★ film fingers to avoid contact with surface film， so as not to leave any dust in the veneer， paste will have a bubble.

★ best ensure a good paste to paste again left dust， paste after the bubble.